@article{14733,
  abstract     = {Redox flow batteries (RFBs) rely on the development of cheap, highly soluble, and high-energy-density electrolytes. Several candidate quinones have already been investigated in the literature as two-electron anolytes or catholytes, benefiting from fast kinetics, high tunability, and low cost. Here, an investigation of nitrogen-rich fused heteroaromatic quinones was carried out to explore avenues for electrolyte development. These quinones were synthesized and screened by using electrochemical techniques. The most promising candidate, 4,8-dioxo-4,8-dihydrobenzo[1,2-d:4,5-d′]bis([1,2,3]triazole)-1,5-diide (−0.68 V(SHE)), was tested in both an asymmetric and symmetric full-cell setup resulting in capacity fade rates of 0.35% per cycle and 0.0124% per cycle, respectively. In situ ultraviolet-visible spectroscopy (UV–Vis), nuclear magnetic resonance (NMR), and electron paramagnetic resonance (EPR) spectroscopies were used to investigate the electrochemical stability of the charged species during operation. UV–Vis spectroscopy, supported by density functional theory (DFT) modeling, reaffirmed that the two-step charging mechanism observed during battery operation consisted of two, single-electron transfers. The radical concentration during battery operation and the degree of delocalization of the unpaired electron were quantified with NMR and EPR spectroscopy.},
  author       = {Jethwa, Rajesh B and Hey, Dominic and Kerber, Rachel N. and Bond, Andrew D. and Wright, Dominic S. and Grey, Clare P.},
  issn         = {2574-0962},
  journal      = {ACS Applied Energy Materials},
  keywords     = {Electrical and Electronic Engineering, Materials Chemistry, Electrochemistry, Energy Engineering and Power Technology, Chemical Engineering (miscellaneous)},
  publisher    = {American Chemical Society},
  title        = {{Exploring the landscape of heterocyclic quinones for redox flow batteries}},
  doi          = {10.1021/acsaem.3c02223},
  year         = {2023},
}

@article{7467,
  abstract     = {Nanomaterials produced from the bottom-up assembly of nanocrystals may incorporate ∼1020–1021 cm–3 not fully coordinated surface atoms, i.e., ∼1020–1021 cm–3 potential donor or acceptor states that can strongly affect transport properties. Therefore, to exploit the full potential of nanocrystal building blocks to produce functional nanomaterials and thin films, a proper control of their surface chemistry is required. Here, we analyze how the ligand stripping procedure influences the charge and heat transport properties of sintered PbSe nanomaterials produced from the bottom-up assembly of colloidal PbSe nanocrystals. First, we show that the removal of the native organic ligands by thermal decomposition in an inert atmosphere leaves relatively large amounts of carbon at the crystal interfaces. This carbon blocks crystal growth during consolidation and at the same time hampers charge and heat transport through the final nanomaterial. Second, we demonstrate that, by stripping ligands from the nanocrystal surface before consolidation, nanomaterials with larger crystal domains, lower porosity, and higher charge carrier concentrations are obtained, thus resulting in nanomaterials with higher electrical and thermal conductivities. In addition, the ligand displacement leaves the nanocrystal surface unprotected, facilitating oxidation and chalcogen evaporation. The influence of the ligand displacement on the nanomaterial charge transport properties is rationalized here using a two-band model based on the standard Boltzmann transport equation with the relaxation time approximation. Finally, we present an application of the produced functional nanomaterials by modeling, fabricating, and testing a simple PbSe-based thermoelectric device with a ring geometry.},
  author       = {Cadavid, Doris and Ortega, Silvia and Illera, Sergio and Liu, Yu and Ibáñez, Maria and Shavel, Alexey and Zhang, Yu and Li, Mengyao and López, Antonio M. and Noriega, Germán and Durá, Oscar Juan and López De La Torre, M. A. and Prades, Joan Daniel and Cabot, Andreu},
  issn         = {2574-0962},
  journal      = {ACS Applied Energy Materials},
  number       = {3},
  pages        = {2120--2129},
  publisher    = {American Chemical Society},
  title        = {{Influence of the ligand stripping on the transport properties of nanoparticle-based PbSe nanomaterials}},
  doi          = {10.1021/acsaem.9b02137},
  volume       = {3},
  year         = {2020},
}